Aireshield Installation Guide
Installing your Aireshield is a straightforward process. Follow the steps below to ensure a smooth and effective installation. No special skills or tools are required beyond basic HVAC access and safety awareness.
🛠️ Step-by-Step Installation Instructions
- Remove the Air Handler Front Panel: Turn off power at the breaker. Remove the front panel to expose the filter compartment.
- Slide Out the Old Filter: Pull out the old HVAC filter and note the airflow direction.
- Slide In the Aireshield: Insert the Aireshield into the slot with the airflow arrow facing the blower.
- Route Wiring: Use the included harness and route through a drilled grommet hole, or just through the filter rack opening.
- Connect Wiring: Connect to the EAC port on your control board or use wire nuts to splice 100 or 220V power wires.
- Secure Wiring: Use wire nuts, zip ties, and sticky pads to organize wires and avoid the blower fan.
⚠️ Safety Tip: Always verify that power is completely off before accessing or wiring any HVAC equipment..
Step 1 Remove the faceplate cover. Route wires through opening on filter rack. 
Step 2 Locate the Neutral on the board. 
Step 3 Connect the brown wire from the wire harness to the neutral (white wires usually, unless labeled differently.) 
Step 4 Locate and connect the blue wire (from the harness) to the EAC port 
Step 5 Double check the blue harness wire is connected to the EAC port, and the brown wire is connected to the neutral port on the control board. 
Step 6 Neaten the slack wire and tape or zip tie the excess harness wires to avoid tangling or interfering with any moving parts.
📄 Download the Full User Manual or View Aireshield User Manual
📽️ Watch the Installation Video
Need Help?
If you need assistance or prefer a professional installation, find a certified installer here.